Job Description (JD)
Nama Program | Penyelenggaraan Peralatan Fabrikasi Wafer Bahagian Hadapan [EE-024-4:2014] |
---|---|
Kod CU | EE-024-4:2014-C01 |
Competency | Core |
Tajuk CU | Wafer Fabrication Engineering Parts Handling |
Penerangan CU | The personnel who possess this competency will be able to carry out Wafer Fabrication Engineering Parts Handling in a wafer fabrication industry Wafer Fabrication Engineering Parts Handling starts with practice clean room protocol; comply to safety and regulation for parts used in respective area, study the parts specification and handle/ care parts as per datasheet handling procedure. The personnel is able to perform Wafer Fabrication Engineering Parts Handling competently, cost efficiently, timely and safely in compliance to preventive maintenance check sheet/ specification/ Standard Operating Procedures (SOP). This competency covers Wafer Fabrication Engineering Parts Handling in wafer fabrication limited to those typical pressure gauges found in common wafer fabrication equipment. |
Tempoh Latihan | 52 |
Objektif Pembelajaran | The person who is competent in this CU shall be able to perform Wafer Fabrication Engineering Parts Handling competently, cost efficiently, timely and safely in compliance to preventive maintenance check sheet/ specification/ Standard Operating Procedures (SOP). Upon completion of this competency unit trainees will be able to: Practice cleanroom protocol Comply to safety and regulation for parts used in respective area Study the parts specification. Handle/ care parts as per datasheet handling procedure |
Pra-Syarat | 0 |